How to use the Voltage Divider Calculator
- Choose to solve for the output voltage or R2.
- Enter the input voltage and resistor values.
- Read the result, current and power in each resistor.
What does this tool do?
Two resistors in series split a voltage in proportion to their values: Vout = Vin × R2 ÷ (R1 + R2). It's a common way to scale a signal down for a microcontroller input.
A divider is only accurate when the load on its output draws much less current than flows through the resistors.
Why use it?
- Two solve modes.
- Current and power shown.
- Load warning.
Use cases
- Scale a sensor or battery voltage for a microcontroller input.
- Set reference voltages in circuits.
- Electronics homework.
5 V down to about 3.3 V
With R1 = 10 kΩ, the exact R2 is 3.3 × 10 ÷ (5 − 3.3) ≈ 19.4 kΩ. The nearest standard value, 20 kΩ, gives 5 × 20 ÷ 30 ≈ 3.33 V, and about 0.17 mA flows through the pair.
Common mistakes
- Powering a load from a divider — it sags as soon as current is drawn.
- Using very small resistors that waste power and heat up.
- Very large resistors that make readings noisy.
The formula
Privacy
The calculation happens instantly in your browser. The numbers you enter are not sent to our servers or saved. There's no account to create and nothing to install.
Frequently asked questions
Can I use a divider as a power supply?
No. Use a voltage regulator; a divider only works when almost no current is drawn.
How big should the resistors be?
For sensor inputs, values from a few kΩ to about 100 kΩ are common.
Why does my measured voltage differ?
Resistor tolerance and the input resistance of your meter or circuit both change the result.
Content last updated . See how M2Toolkit works.