How to use the Stress Calculator
- Choose stress or Young's modulus.
- Pick what to solve for.
- Enter the values and read the result.
What does this tool do?
Normal stress is force per unit area: a 10 kN pull on a 5 cm² bar creates 20 MPa of tensile stress. Comparing stress with a material's strength tells you how close it is to yielding.
Young's modulus is the ratio of stress to strain in the elastic range — about 200 GPa for steel and 69 GPa for aluminium.
Why use it?
- Stress and modulus modes.
- MPa, GPa and psi.
- Solve for any variable.
Use cases
- Engineering and physics coursework.
- Quick checks on bolts, rods and cables.
- Comparing materials for a design.
A 10 mm steel rod pulled with 10 kN
Area = π × 5² ≈ 78.5 mm², so the stress is 10,000 ÷ 78.5 ≈ 127 MPa — about half the yield strength of mild steel (around 250 MPa). Strain = 127 MPa ÷ 200 GPa ≈ 0.064%, so a 1 m rod stretches about 0.64 mm.
Common mistakes
- Mixing mm² and m² — 1 N/mm² is 1 MPa.
- Using Young's modulus beyond the elastic range.
- Ignoring safety factors in real designs.
The formula
Accuracy and limits
- For learning and quick checks. Real engineering decisions should be verified by a qualified professional.
Privacy
The calculation happens instantly in your browser. The numbers you enter are not sent to our servers or saved. There's no account to create and nothing to install.
Frequently asked questions
What is a pascal?
One newton per square metre. Engineers usually use MPa (N/mm²) and GPa.
Tensile or compressive?
Pulling creates tensile stress; pushing creates compressive stress. The formula is the same.
Is this enough for a real design?
No. Real parts need safety factors and checks for buckling, fatigue and stress concentrations.
Content last updated . See how M2Toolkit works.