Skip to content
M2TOOLKIT

Education · free tool

Beam Load Calculator

Check reactions, bending moment and deflection for a simply supported beam.

Use it as often as you like — it's free, with no sign-up and no limits.

  • Education
  • Free
  • No sign-up
  • Nothing is sent or stored
  • Updated
m
kN
GPa

Steel ≈ 200, aluminium ≈ 69, softwood ≈ 10.

cm⁴

Result

Maximum bending moment
30 kN·m
Reactions R₁ / R₂
10 / 10 kN
Maximum shear
10 kN
Maximum deflection
5.38535 mm
Span ÷ deflection = L/1,114
How it was calculated
  1. R₁ = R₂ = P ÷ 2
  2. M_max = PL ÷ 4
  3. δ_max = PL³ ÷ 48EI
For planning and learning. Real structural design must be checked by a qualified engineer against your local code.

The calculation happens instantly in your browser. The numbers you enter are not sent to our servers or saved.

How to use the Beam Load Calculator

  1. Choose the load type.
  2. Enter the span and load.
  3. Enter the material's elastic modulus E and the section's second moment of area I.

What does this tool do?

A simply supported beam rests on two supports at its ends. The load creates reactions at the supports, shear forces and a bending moment that peaks under a point load or at mid-span for a uniform load.

Deflection depends on stiffness: E is the material's elastic modulus and I describes the cross-section's shape. Deflection limits like span/360 are common in building design.

Why use it?

  • Three common load cases.
  • Reactions, shear, moment and deflection.
  • Span-to-deflection ratio shown.

Use cases

  • Structural engineering coursework.
  • Quick checks on shelves, joists and lintels.
  • Comparing beam sizes and materials.

A 4 m beam

A 10 kN point load at mid-span gives 5 kN reactions at each support and a maximum moment of 10 × 4 ÷ 4 = 10 kN·m.

A uniform 5 kN/m load gives the same 10 kN·m (5 × 4² ÷ 8). A span/360 limit allows about 11.1 mm of deflection.

Common mistakes

  • Mixing units — keep N, mm and MPa together, or kN, m and kPa.
  • Using the wrong second moment of area for the beam's orientation.
  • Treating these results as a final design without a qualified engineer's check.

The formula

Point load at mid-span: M = PL ÷ 4, δ = PL³ ÷ 48EI
Uniform load: M = wL² ÷ 8, δ = 5wL⁴ ÷ 384EI

Accuracy and limits

  • For learning and quick checks. Real engineering decisions should be verified by a qualified professional.

Privacy

The calculation happens instantly in your browser. The numbers you enter are not sent to our servers or saved. There's no account to create and nothing to install.

Frequently asked questions

What is E?

The material's stiffness: about 200 GPa for steel, 69 GPa for aluminium and roughly 10–12 GPa for timber.

What is I?

The second moment of area. For a rectangle it's b × h³ ÷ 12, so depth matters far more than width.

Why span/360?

It's a common deflection limit for floors, so they don't feel bouncy or crack finishes.

Content last updated . See how M2Toolkit works.

Other tools people use alongside the beam load calculator.